Introduction

RouterOS password can only be reset by reinstalling the router OS or using the reset button (or jumper hole) in case the hardware is RouterBOARD. For X86(CHR) devices, an only complete reinstall will clear the password, along with other configurations. For RouterBOARD devices, several methods exist, depending on our model.

Reset From RouterOS

If you still have access to your router and want to recover its default configuration, then you can:

  • Run the command"/system reset-configuration"from a command-line interface;
  • Do it fromtheSystem -> Reset Configurationmenu in the graphical user interface;

Using Reset Button

RouterBOARD devices are fitted with a reset button which has several functions:

  • Loading the backup RouterBOOT loader
    Hold this button before applying power, release after three seconds since powering, to load backup boot loader. This might be necessary if the device is not operating because of a failed RouterBOOT upgrade. When you have started the device with the backup loader, you can either set RouterOS toforce backup loaderin the RouterBOARD settings or have a chance to reinstall the failed RouterBOOT from a ".fwf" file (total3 seconds)
  • Resetting the RouterOS configuration
    Hold this button until LED light starts flashing, release the button to reset RouterOS configuration to default.
  • Enabling CAPs mode
    To connect this device to a wireless network managed by CAPsMAN, keep holding the button for 5 more seconds, LED turns solid, release now to turn on CAPs mode. It is also possible to enable CAPs mode via the command line, to do so run the command"/system reset-configuration caps-mode=yes";
  • Starting the RouterBOARD in Netinstall mode
    Or keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers. You can also simply keep the button pressed until the device shows up in the Netinstall program on Windows.


You can also do the previous three functions without loading the backup loader, simply push the button immediately after you apply power. You might need the assistance of another person to push the button and also plug the power supply at the same time!

How to reset configuration

1) Unplug the device from power;

2) Press and hold the button right after applying power;

Note: hold the button until LED will start flashing;

3) Release the button to clear configuration;

If you wait until LED stops flashing, and only then release the button - this will instead launch Netinstall mode, to reinstall RouterOS.

Jumper hole reset

老Routeios版雷竞技官网入口rBOARD模型也合身with a reset jumper hole. Some devices might need an opening of the enclosure, RB750/RB951/RB751 have the jumper hole under one of the rubber feet of the enclosure.

Close the jumper with a metal screwdriver, and boot the board until the configuration is cleared:

Jumper reset for older models

Thebelowimage shows the location of the Reset Jumper on older RouterBOARDs like RB133C:


Don't forget to remove the jumper after the configuration has been reset, or it will be reset every time you reboot!

  • 没有标签