The product photo shown is 3 chain but technical spec show is Dual chain...
which one is the correct answer???
http://routerboard.com/product/237
My question is for the part number 3x3 (30 db) Miktotik dish, not the routerboard motherboards or electronics.Order code RB921UAGS-5SHPacT-NM RB921UAGS-5SHPacD-NM RB922UAGS-5HPacT-NM RB922UAGS-5HPacD-NM
again, reading is very hardhttp://i.mt.lv/routerboard/files/NetMet ... 134735.pdf
No, it is RPSMA.it's sma not RP-sma right...
MikroTik is producing NetMETAL, there is very high demand for this product (demand was much higher that we expected, upcoming batches until December has been booked out by Distributors, call around to see who can offer you best lead times).
There are no any known issues with MANT antenna and NetMETAL, MANT has two chains (and can be used together).
Third chain should be disabled by software. Two chains provide you with ~866 Mbps datarate.So, what is the configuration should be done on RB to configure it to use Dual chain instead of triple.
Contact your distributor and ask for any available triple chain antenna, that might fit your requirements.In addition, I can't find mANT30 here in Lebanon, which alternative you recommend to use with Net Metal 5 RB921 Triple Chain.