I am seeing this here with multiple new units running in data centers. We are running 6.43.11 on all units. I have one running 6.43.12, also in a data centre, no other devices in the rack show any signs of power issues. Checked winbox, firmware shows "6.43.12". Last night, logs indicate B...

I did some more testing on this today. I've updated all of my test lab devices (2x HexS, 1x RB1100, the CRS328) to 6.43.11 (current stable). Included in this was a firmware update, as usual, plus the reboot associated. I've now also tested the "Safe Mode" feature in conjunction with this i...

这是一个很好的观点,pcunite——我没试过yet. I tried using the terminal inside of winbox to first set the ingress-rate, then unset the ingress-rate. Much like in GUI, success. However, using terminal to unset egress-rate causes the same lockup. A few seconds later, traffic ceases, Winbox ...

Hi all, I've recently bought a CRS328-4C-20S-4S+RM with intent to use as a simple access layer switch - dot1q trunk in via one of the SFP+ ports, then client connections out via the SFP ports. Each client has a dedicated VLAN untagged/retagged at their respective port. The switch shipped with Router...

Does anyone else run SwOS v2.8 on a CSS326-24G, monitoring with Observium?

I see a line in the changelog that says "provide SFP port healt information via SNMP" - should I expect DOM (tx/rx power) to be made available via SNMP as a result of this?

I tried to do the same thing, but I found that I had to assign the hotspot to the bridge.

After doing this, clients on ether2 AND wlan were connecting to the hotspot.