你好,我有一个新的RB850Gx2期间,有一个问题the setup. after investigation i can reproduce my error with a really simple setup. i install a fresh 6.49.3 und configure a VLAN IF on ether5 and then create an IP address on the VLAN IF. /interface vlan add interface=ether5 name=test-vlan vlan-id=...

hi, i have the same probem, but it occured in version 6.41, older versions work. the routes don't use the connected route to resolve the gateway. here an example: 1 ADC dst-address=10.0.0.4/31 pref-src=10.0.0.5 gateway=zeratul gateway-status=zeratul reachable distance=0 scope=10 2 S dst-address=10.0...

are there plans to add NAT for IPv6 ?
at home i have dynamic ipv6 from the provider and a static ipv6 net with no flatrate at tunnelprovider.
the simplest solution is to NAT unknown networks und known networks without NAT for static firewall config.

are there plans to add NAT for IPv6 ?
at home i have dynamic ipv6 from the provider and a static ipv6 net with no flatrate at tunnelprovider.
the simplest solution is to NAT unknown networks und known networks without NAT for static firewall config.

i have tested the rc20 release on my rb3011.
interface flapping on ether6-10 is not solved.
now i have problems with fasttrack,
i have a mange rule to add a route mark to packets and if the connection is set to fasttrack it seems that is not added anymore, with stable this works without problems.

hi, i have a great problem with rc4 and rc5pre. i think the ssh daemon is crashing. after reboot or restarting the ssh service under "ip service dis ssh ; ip service en ssh", it works for 10 seconds and then the port is closed, you can see this with tcptraceroute on port 22 then i have do...

hi, i have a great problem with rc4 and rc5pre. i think the ssh daemon is crashing. after reboot or restarting the ssh service under "ip service dis ssh ; ip service en ssh", it works for 10 seconds and then the port is closed, you can see this with tcptraceroute on port 22 then i have don...

ok your right

with mii-type 2 it works exactly as expected.
its not so cool that the standard lacp not work but its ok for me with static channel.

thanks

i have a problem with bonding-xor, too.
if i disconnect one cable then the half packets are lost.
i have configured it for mii-type 1 for monitoring.
the router does not disable the disconnected port in the bond.
on the switch side i see that he put the port out of the channel.

hi, i have a problem with the connection between my switch and router. i want to set up a bond with LACP on both sides. only this bond works, but if i create vlan IFs on this bond i have crazy situation. some vlan IFs work and some not. i think the switch or the router send packets over an port of t...