Does Cloud Core Router support irqbalancing ?
How many cores can operate each ethernet port ?

@fewi:主路由器Vyatta同行3日运行边界网关协议s - and i could make ospf instead of using vrrp. I would say that i even should:). But vrrp is much easier / faster. I set up on main router ie. -> ip r a 178.200.216.0/22 via IP_ADDRES_OF_VRRP and it is done . If R0 goes down - R1 takes its job. Whe...

Hi, i am trying to implement some redundancy:) Please correct what you think is wrong. Thanks for any suggestion. All below is in testing lab. There will be different IP addresses in production . As You can see on the diagram... We have 2 PPPoE servers connected to a switch serving clients PPPoE sim...

Thanks Tom for testing this hardware. I appreciate it a lot. Anyway - we upgraded one of our BRAS serwers terminating 350 PPPoE sessions by mistake :) to version ROS 5.0rc7. It was a disaster. CPU was 100% almost all the time. All interfaces were disappearing and appearing . So i think we will wait ...

5.x is developement . So i will not risk installing it on production machine that terminates 1k pppoe sessions.

Is that 100% sure that Intel 82574L NIC will not work in 4.x ? I see some e1000 changes in 4.x changelog..

No, it needs the newer Linux kernel (in RouterOS 5.x) for support. Tom Thanks Tom for answer. That is shitty - because 5.x is not stable to put it on box that would be responsible for pppoe for 1k or 2k sessions. Is that 100% sure that Intel 82574L NIC will not work ? I see some e1000 changes in 4....

Does Intel 82574L work in 3.30 or 4.16 ?

What about MT 3.30 or 4.16 ?
Does it work on this hardware?
Are network cards OK?

Hi,
what hardware is suitable for server 2000 pppoe concurent sessions and sfq shaping them?

What are your suggestions?

Strange.
We replaced thet x86 box with some other.
When it was not connected to the production network ( it was not running 300 pppoe sessions ) the downrade was OK.

Slightly offtopic.
How many sessions do you have ?
Is it possible that MT can handle up to 2000 sessions - shape the traffic and nat them - without problem?

Hi,
we upgraded to 5rc7 on x86 but we noticed that interfaces disappear and appear .
We tried to downgrade to 4.16.
I downloaded all packages - put them to the mikrotik - run /system package downgrade - the box rebooted BUT no effect.
It is still 5rc7.

Please help - how to downgrade.

We also suffer from that issue on 30-40 MT with PPPoE Server enabled.

After some days/hours without any regularity - it just simply hangs.

Hi, I would like to monitor rx-signal-strength / tx-signal-strength and rx-rate/tx-rate on nstreme2 interfaces via SNMP in RouterOS 3.14 . What OID is responsible for rx/tx signal and rate ? I can not find anything in snmpwalk -v2c -c public 10.0.0.22 -m /tmp/MIKROTIK-MIB.txt or snmpwalk -v2c -c pub...