Has there been any communication regarding CAKE from the devs; apart from the one-liner in the changelog?

Ditto the above; I'm running 7.2.3 here and have MTU 1500 :)

Hi guys, I need help. Is there any chance how to override default MTU for PPPoE introduced in Release 7.2rc1? *) pppoe - use default MTU of 1492; I need higher (1500) but it is always changed to 1492 automatically. Previous versions were fine. Thank you for any advice. Providing your ISP supports b...

Cake is interface queue only.

Do you mean that the interface needs to be set to eth1 (as opposed to the pppoe-interface) or rather the upcoming change in ROS 7.3 that does not allow cake as a simple queue type?

Thanks for the replies all. @tdw - Will get the mru, mtu and mrru settings when I can, away at the mo. ISP wise its "Babble". @msatter - will check IPv6 address when back. At the risk of appearing stupid, how does one switch off IPv6 on the Tik? Just disable IPv6 in the PPP profile instea...

嗨！有人能看一看我的蛋糕配置和吗tell me if there's anything I can do to get as close to line-speed as possible. Some background: Zen VDSL2 connection (80/20) into Vigor 130 modem (VLAN 101); PPPoE connection established via RB4011 on ether1. Jumbo packets enabled (ether1 MTU 1508;...

I've got a dual-wan setup, however 7.1rc1 doesnt seem to like the way the routing is setup: # aug/30/2021 09:59:55 by RouterOS 6.48.4 # software id = QHFP-3FXW # # model = RB4011iGS+5HacQ2HnD # serial number = A2830A726A10 /ip route add check-gateway=ping distance=1 gateway=1.1.1.1 add check-gateway...

Thats odd - I've got pfs set in phase 2 and the IKEv2 tunnel establishes correctly:

Yes, they establish correctly. But do they rekey without issue? Have a look at your log...

You are right. SA expires before rekey. Set pfs to none and will monitor..

Yes, that's what should be set to none IMHO. Look at first line, dh-group=modp4096 is used for dh in phase 1 and for PFS in phase 2. Thats odd - I've got pfs set in phase 2 and the IKEv2 tunnel establishes correctly: # model = RB4011iGS+5HacQ2HnD # serial number = xxxx /ip ipsec profile add dh-grou...

Have a site-to-site (IKEv2 & pre-shared key) running between my RB4011 and a USG4 appliance in the office. Configuration unchanged from 6.46.5. If I update to 6.47b60 then whilst the tunnel is still established (confirmed by SA status within Ipsec menu) I cant access the other site. No pings etc...